Read the Product Evidence
Acoustic information should describe the product and the conditions under which it was assessed.
Start with the current datasheet for the exact Noise Defender model. Review the relevant report alongside any headline acoustic figure so that the measurement and tested arrangement are clear.
Check the product identity, test method and scope of the report. Confirm that the document applies to the panel being specified and distinguish the individual panel result from the performance of a complete installation.
If a requirement refers to a particular test method or classification, ask for the corresponding evidence before including it in the project specification.
Assess the Site Arrangement
On-site performance depends on the noise source, screen layout and surrounding environment.
Screen height, position, continuity and openings can affect the result at the receiver. Review these factors alongside the panel information when developing a noise-control plan.
Information for Your Specification
Product datasheets
Request current dimensions, weight, panel construction and acoustic information for the model you are considering.
Request a datasheetAcoustic test reports
Review the measurement, method and tested arrangement. Ask for the report associated with your chosen product.
Request a reportInstallation guidance
Confirm the mounting arrangement, supporting structure and handling requirements using current product instructions.
Request guidanceProject advice
Share the source location, working area and nearby receivers to discuss the information required for your project.
Discuss your projectAcoustic Performance FAQs
Does a laboratory result guarantee the same reduction on site?
A laboratory result describes the assessed product and test conditions. The installed result also depends on the noise source, screen position, height, openings and surrounding environment.
Which acoustic figure should I use in a specification?
Use the current information for the exact model and review the associated report. Confirm the metric, test method and scope against the project requirement.
Where are the current test reports?
Request the report for the selected model through Technical Resources or contact Noise Defender. Only approved current documents will be made available for download.
What information helps with project advice?
Provide the noise source, operating hours, a site plan, nearby receivers and any project noise requirement. Include the proposed screen layout if one is available.
